15-year precision mould making

   The development of precision mold parts products. For every day of the year, precision mold parts machine running, precision mold parts should be done once a week. And at the end of the year is a good time, to give these precision mold parts for a routine lubrication and maintenance.
   Cross check the heater resistor values. You should be at the beginning of precision mold parts heater is used, it has measured precision mold parts resistance value, and at the end , it is again measured and compared. If the resistance is floating ± 10%, should consider replacing the heater, it can not fail at the critical moment of precision mold parts production process. If never measure the initial resistance value, then measured again, and the resulting value for future check the heater when the reference data.
   View the guide column and guide sleeve if there are signs of wear. To find whether there is a scratch or rub the other traces, precision mold parts wear is caused due to lack of lubrication. If the trace is just appears, then you also can give the guide post and the guide sleeve add lubricant to extend its life. If the wear is very serious, it should be replaced with new parts. Otherwise, may not be well with the cavity and precision mold parts, which leads to precision mold parts cavity wall thickness is not a component.
   Connected by a hose at the water outlet, let the water through the pipe until the bucket. If the out flow of water is not clear or colored,there may be rusty phenomenon occurs, and the flow is obstructed means somewhere jam. If these problems found, will all the pipes again drill (or take anyway you most commonly used for cleaning), in order to ensure smooth. Water treatment system to improve the plant to prevent future precision mold parts problems caused by rust and blockage.
  Cleaning the precision mold parts. After a year of time, precision mold parts due to gas accumulation and membranous impurities become dirty. Recommended every 6~12 months with mold cleaning agent to clean a. After cleaning, the thimble is coated with a layer of lubricant to prevent scratches or fracture.That is the development of precision mold parts products.
   Above is the development of precision mold parts products maintenance skills, the hope can help you, do precision mold parts maintenance can prolong the service life of  the precision mold parts, but also can improve the efficiency in the use of.